How To Make A Free Energy Generator At Home With Magnets
opera.com May 12, 2020 1:23 PM
HOW TO MAKE A FREE ENERGY GENERATOR AT HOME
Do you like to build things at home? If yes then you are very lucky because you have come to the right place because in this article, I will be teaching you how to build your own free energy generator at home using just a magnet and a copper wire. To Me, this is one of the best projects to do at home because it is relatively easy and simple to build provided that you follow the steps in this article correctly. I know that most of you didn’t even know that a magnet can be more useful for building things instead of pulling and pushing other things. Well good news for you because in this article, I will be teaching you how to build a free energy generator with just a magnet and some copper wire.

Materials
For this small project, you will need two round magnets, some copper wire, a solid base or platform e.g. wood or Styrofoam.

Procedure
1.The first thing to do when following through with this project is to cut out your base into a square or a rectangle. It is on this base that the other constituents of the free energy generator would be positioned upon



2.The second step to perform is to carefully place the first round magnet on the left side of the platform.
3.The third step to perform is to place the second round magnet on the other side of the platform but make sure it is not too far away from the other magnet. In fact just make the distance between the two magnets about 3 centimeters from each other.

4. After this has been done, make an effort to glue the magnets to the platform so as to prevent the components of your free energy generator from falling off the platform

5.After this has been done, you will the take your copper wire and spin it around the magnets individually as many times as you can but not less than twenty times.

6. After doing this,you will then proceed to pick up the ends of the copper wire and attach it to your appliance. Note that the rating of the appliance should not be more than five volts. So for this I suggest that you should use a brushless DC motor.


7.Connect both ends of the copper wire terminals to the wires of the DC motor.
If you have done this right, you should notice the DC motor begin to spin.

If you liked this article, feel free to like, share and comment on this post.

Thank you.